Shutdown; Major Technical Data - Halfords HP 2800 Instruction Manual

by twisting collar clockwise towards the 'negative'
symbol (see figure 6). Alternatively detergent can
be applied when using a low pressure attachment
with the lance, e.g. fixed brush, rotary brush.
3. Be sure all detergent is flushed from system after use – add water to system to do this.
Motor Protection
To prevent damage due to overheating the pump motor is fitted with a thermal switch.
If during use the pressure washer stops - turn off and unplug from the mains power supply
and allow to cool for at least 10 minutes.
If the motor continues to cut out due to overheating contact the Customer Careline Number
0845 601 7834.

Shutdown

1. Be sure all detergent is flushed from the system.
2. Turn off th e pressure washer at on/off switch on unit.
3. Turn off the water supply.
4. After the motor and water supply are turned off, trigger
CAUTION: NEVER turn wate
to the pump and/or motor.
WARNING! NEVER disconnect the high-pressure discharge hose from machine while system
is pressurised. To depressu
2-3 times.
5. After each use, wipe all surfaces of the pressure washer with a clean, damp cloth.
Storage
D o not store the pressure washer outdoors. Do not store the pressure washer where it might
freeze. Da mage due to freezing is not covered by the warranty.

Major Technical Data

Working Pressure
Working Flow Rate
Max. Pressure Wate r Supply
Motor Capacity
Power Supply Vo ltage
Max. Water Temperatur e
8
r supply off before turning motor off. Serious damage could occur
rise, turn motor off, turn water supply off and squeeze gun trigger
ITEM
Customer Careline: 0845 601 7834
Turn the spray nozzle clockwise
to decrease the pressure
Figure 6 Adjusting pressure
the gun to depressurise system.
HP 2800
1 2 .5 Mpa (125 bar)
7.1 l/min
0.4 Mpa (4 ba r)
2800W
2 40V~50H z
50°C