Troubleshooting Chart - Halfords HP 2800 Instruction Manual

Troubleshooting chart

Symptom
Pressure washer
does not start
Pump does not
reach necessary
pressure
Low pressure
Fluctuating Pressure
Motor stops
suddenly
No detergent
Suction – units with
attachable
applicators
Unit begins to
smoke
R ecycling
T his product bears the selective sorting symbol for waste electrical and
electronic equip ment (WEEE). This means that this product must be
handled pursuant to European Directive 2002/96/EC in order to be
recycled or dismantled to minimize its impact on the environment.
For further information, please contact your local or regional authorities.
Electronic products not included in the selective sorting proces
potentially dangerous for the environment and human health due to the pre
substances.
Possible cause(s)
1 .Unit is pressurized
2. Plug did not well connected or
electric socket is faulty
3. Extension cord too long or wire
size too small
4. Main voltage supply too low
1. Water inlet filter is clogged
2.Pump sucking air from hose
connections
3. Nozzle worn or not correct size
1. Pump sucking in air
2. Clogged nozzle
1. Extension cord too long or wire
size too small
2. Thermal safety switch has
tripped due to overheating
1.Detergent applicator clogged
1.Overheated, overloaded or
damaged motor
Customer Careline: 0845 601 7834
Corrective Action(s)
1. Squeeze trigger on gun
2. Check plug, socket
3.Remove extension cord
4. Check that main supply
voltage is adequate
1.Clean water inlet filter
2.Check that connections
and locking ring are
properly tightened
3. Contact customer
Careline, do not return
pressure washer to store
of purchase
1.Check orange pressure
collar adjustment,roate
pressure adjusting orange
collar anti clockwise to
increase pressure(page 6)
1. Check that hoses and
connections are tight
2. Clean with tip cleaner
(see page 6)
1. Remove extension cord
page4)
(
2. Check that main supply
voltage age corresponds
to specifications
3.Turn of f and unplug
from the mains power
supply and allow to cool
for at least 10 minutes,if
the motor continues to
cut out due to overheating
contact the Customer
Careline Number
084 601 7834.
1. Clean applicator with
warm water
2. Replace applicator
1.Turn of f uni t and
contact customer careline
s are
sence of hazardous
9