Table of Contents
Advertisement
Connecting the drain hose
!
We advise against the use of hose extensions; if it is
absolutely necessary, the extension must have the same
diameter as the original hose and must not exceed 150 cm
in length.
Electrical connections
Before plugging the appliance into the electricity socket,
make sure that:
• the socket is earthed and complies with all applicable laws;
• the socket is able to withstand the maximum power load
of the appliance as indicated in the Technical data table
(see opposite);
• the power supply voltage falls within the values indicated
in the Technical data table (see opposite);
• the socket is compatible with the plug of the washing ma-
chine. If this is not the case, replace the socket or the plug.
!
The washing machine must not be installed outdoors, even in
covered areas. It is extremely dangerous to leave the appliance
exposed to rain, storms and other weather conditions.
!
Once the machine has been installed, the electricity
socket should be easily accessible.
!
Avoid using any extension cord or multiple socket outlet.
!
CAUTION: if this appliance is supplied from a cord
extension set or electrical portable outlet device, the cord
extension set or electrical portable outlet device
must be positioned so that it is not subject to splashing or
ingress of moisture.
Connect the drain hose,
without bending it, to a drai-
nage duct or a wall drain
located at a height between
65 and 100 cm from the
floor;
alternatively, rest it on
the side of a washbasin
or bathtub, fastening the
duct supplied to the tap
(see figure). The free end
of the hose should not be
underwater.
!
The cable should not be bent or compressed.
!
The cable should be replaced only by authorised techni-
cians.
!
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified per-
sons in order to avoid a hazard.
Warning! The company shall not be held responsible in the
event that these regulations are not respected.
The first wash cycle
Once the appliance has been installed, and before you use
it for the first time, run a wash cycle with detergent and no
laundry, using the wash cycle 2.
Technical data
PWC 7127 S
Model
width 59.5 cm
Dimensions
height 85 cm
depth 55 cm
Capacity
from 1 to 7 kg
Electrical
please refer to the technical data plate
fixed to the machine
connections
maximum pressure 1 MPa (10 bar)
minimum pressure 0.05 MPa (0.5 bar)
Water connections
drum capacity 52 litres
Spin speed
up to 1200 rotations per minute
Energy rated
programmes
program Cotton 2; temperature 60°C;
1200 rpm, using a load of 7 kg.
according to
AS/NZS 2040.2
This appliance conforms to the following
EC Directives:
- 2004/108/EC (Electromagnetic Compa-
tibility)
- 2006/95/EC (Low Voltage)
- 2002/96/EC
AUS
3
Hide quick links:
Advertisement
Table of Contents
