Hyundai L500 SERIES Installation And Operation Manual page 6

ENGINE BREAK-IN
INITIAL BREAK-IN PROCEDURE
The first 20 hours of operation is the
engine break-in period. During this period,
it is important that the engine is operated
as outlined below.
• DO NOT operate engine at idle rpm for
extended periods of time during the first 10
hours.
• DO NOT operate at any one constant speed
for extended periods of time.
• DO NOT exceed 75% of full throttle during the
first 10 hours except during the engine initial
Break-In Procedure. During the next 10 hours,
occasional operating at full throttle (5 minutes
at a time maximum) is permissible.
• AVOID full throttle accelerations from neutral
position.
• DO NOT operate at all full throttle until engine
reaches normal operating temperature. (40℃)
• FREQUENTLY CHECK engine oil level and
add oil if necessary.
INSTALLATION & OPERATION MANUAL
L500 Series
DO NOT DRIVE IN SPACE WHERE THERE IS NO AIR CIRCULATION.
EMISSION GAS IS HARMFUL.
• Installation must be done and repairs must be
performed using
procedures specified by Hyundai SeasAll.
• The limited warranty does not apply to any
damage to our products caused by the
installation or use of parts and accessories
which are not manufactured or sold by us.
• Check for compliance with torque tightening
requirements. (Contact your Hyundai SeasAll
dealer or refer to the manual)
• Any gaskets, O-rings, seals or other sealing
parts should be replaced with new parts during
repairs.
WARNING
- 5 -
the special tools and