Thump Basic Operation; Using Thump With Your Phone; Starting A Call; Talking - Qak Thump Z-W88 User Manual

Thump Basic Operation

After your Thump is paired with your phone, you can use it to enjoy the mobile stereo music
or answer the phone.
Using Thump for calls

Starting a call

Dialing: To dial a call, use your phone to dial a number as usual. You can also press the S4
key twice to start a call to the last dialed number. While connecting the call, your Thump
will sound ring tones.
Answering: When receiving a call, first a single tone will automatically sound in your Thump
then followed by ring tones and the red light will flash once per second.

To answer a call, press S4 on your Thump or press the answer key on your mobile phone.
The red light will flash 2 times/second.

To refuse a call, press S1 on your Thump. It will direct the call to the mobile phone
answering service. To return to the mobile phone answering mode, press S1 again. Some
phones may not support this feature.

Talking

While you are talking, you can press S5, "Volume+", or S6, "Volume-" to adjust the volume
through fifteen levels. A double tone will sound in your Thump when at the lowest or
highest setting.

Ending calls

Press S4 on your Thump or the end call key on your mobile phone, or the other party may
disconnect to end a call. The red light will flash once/second during the disconnect process.
After that, your Thump will automatically return to playing stereo music and the red and/or
blue lights will flash slowly to indicate stereo or mono music status.

Listening to stereo music

After pairing with your phone:

Press S1 to play music.

Press S3 to skip to the

Press S2 key to skip to the previous song.

Press S1 to pause music and enter stand-by mode. Press S1 again to resume music.

Press S5, "Volume+", or S6, "Volume-" to adjust the volume.
Note: Due to different designs on different phones, while your Thump is in stand-by mode,
the Bluetooth connection may be automatically disconnected
next song.
Thump User Guide 6