1. SAFETY SYMBOLS & PRECAUTIONS 1.1. SAFETY SYMBOLS This manual uses the safety symbols below. They denote critical information. Please read them carefully. WARNING Failure to abide by the information in a WARNING may result in serious injury and can be life threatening.
Page 4
Use the enclosed power cord and connect to the standard power outlet of your country. Be sure to remain within the rated voltage of the power cord. Not doing so may result in fire or electric shock. To disconnect the power cord, grasp the plug firmly and pull. Tugging on the cord may damage and result in fire or electric shock.
CAUTION Handle with care when carrying the unit. Disconnect the power cord and signal cables and remove the optional unit. Moving the unit with the cord or the option attached is dangerous. It may result in injury. When handling the unit, grip the bottom of the unit firmly with both hands ensuring the panel faces outward before lifting.
2. INTRODUCTION Thank you very much for choosing this monitor. 2.1. Features - VGA analog input - Resolutions up to SXGA 1920x 1080 - Power management system conforms to VESA DPMS standard. - Supports DDC1/2B for Plug & Play compatibility. - Advanced On Screen Display (OSD) control for picture quality adjustment 2.2.
3. CABLE CONNECTION 3.1. Before Connecting Before connecting your monitor to the computer, change the display screen settings (Resolution and frequency) in accordance with the charts below. Note: - The lower display modes like 640x 480, automatically enlarge to the maximum display mode (1920 x 1080), and some lines of the characters may become fuzzy.
4. ADJUSTMENT This touchmonitor will not likely require adjustment. Variations in video output and application may require adjustments to the touchmonitor to optimize the quality of the display. For best performance, the touchmonitor should be operating in native resolution 1920 x 1080. Use the Display control panel in Windows to choose 1920 x 1080 resolution.
4.2 OSD MENU Adjustments and Settings The following table shows all adjustment and setting menus. Main Menu Sub Menu Reference Auto Adjust Adjust the picture automatically Gamma 1 Gamma 2 Gamma 3 Choose suitable mode according to different Gamma Gamma 4 application Gamma 5 Gamma 6...
Page 10
Note: Horizontal bars may not completely disappear from the screen depending on the computer. (3) The screen position is incorrect. → Use the <Position> adjustment. The <Position> adjustment moves the image to the correct position. Select <Position> and adjust the position by using the Up and Down buttons.
TROUBLESHOOTING If a problem persists even after applying the suggested remedies, contact a dealer. Problems Points to check with Possible Solutions 1. No picture Check that the power cord is correctly connected. If the problem persists, Indicator status: Off turn off the monitor power for a few minutes, then turn it back on and try again.
6. CLEANING Periodic cleaning is recommended to keep the monitor looking new and to prolong its operation lifetime. Note: Never use thinner, benzene, alcohol (ethanol, methanol, or isopropyl alcohol), abrasive cleaners, or other strong solvents, as these may cause damage to the cabinet or LCD panel. Cabinet To remove stains, wipe the cabinet with a soft, lightly moistened cloth using a mild detergent.