Jeep 1997 Grand Cherokee Service Manual page 1114

8W - 01 - 8
SERVICE PROCEDURES (Continued)
(4) Using special tool 6742 release the locking fin-
gers on the terminal (Fig. 13).
(5) Pull on the wire to remove it from the connec-
tor.
(6) Repair or replace the connector or terminal, as
necessary.
Fig. 13 Using Special Tool 6742
TERMINAL/CONNECTOR REPAIR—THOMAS AND
BETTS CONNECTORS
(1) Disconnect battery.
(2) Disconnect the connector from its mating half/
component.
(3) Push in the two lock tabs on the side of the
connector (Fig. 14).
Fig. 14 Thomas and Betts Connector Lock Release
(4) Insert the probe end of special tool 6934 into
the back of the connector cavity (Fig. 15).
(5) Grasp the wire and tool 6934 and slowly
remove the wire and terminal from the connector.
(6) Repair or replace the terminal.
(7) Install the wire and terminal in the connector.
Fully seat the terminal in the connector.
8W - 01 GENERAL INFORMATION
Tabs
Fig. 15 Removing Wire Terminal
(8) Push in the single lock tab on the side of the
connector (Fig. 16).
Fig. 16 Single Lock Tab
CONNECTOR REPLACEMENT
(1) Disconnect battery.
(2) Disconnect the connector that is to be repaired
from its mating half/component
(3) Remove the connector
required (Fig. 17)
Fig. 17 Connector Locking Wedge
ZG
locking wedge, if