Spray Function; Cleaning And Maintenance - Salton elite STI 01E Instructions For The Use And Care

SPRAY FUNCTION

This function can be used any time and it is not affected by the ironing temperature. An electrical pump
in the ironing station supplies the small internal reservoir with water for spraying.
1. When the internal reservoir is empty, after intensive spraying, push the steam trigger (refer General
Description (2)) for about 1 minute to refill.
Note: Refilling is complete when you see/hear steam being released from the steam vents on the
soleplate.
Filling and refilling the internal reservoir must be executed at a temperature setting between "● ●"
2.
to max. It is not possible to refill the reservoir at a temperature setting below "● ●".
CLEANING & MAINTENANCE
1. After using, first unplug the unit and allow it to cool down before cleaning.
2. Empty out the remaining water from the station/tank. Hold the soleplate away from you while doing
this incase it is still hot.
3. Wipe the soleplate with a soft wet cloth and keep it level and smooth avoiding metal-friction.
4. Scrub incrustation off the spraying nozzle with a toothpick.
5. Wash the inside of the water tank frequently. First fill with water, and then sway it from side to side
finally pouring out the water through the water opening.
6. Don't use strong acid or alkali products on the iron as this may damage the frame and produce a
colour change to the body of the unit.
7. Do not use harsh abrasive cleaners or solvents when cleaning the iron.
8. Pour out water in the water tank completely after using every time.
ANTI-CALCIFICATION CARTRIDGE
1. At the back of the base is a replaceable cassette which purifies the water in the tank before
entering the internal reservoir.
2. Depending on the number of times the iron is used as well as the hardness of the water in your
region, this cassette should last for 6 months, at 2hrs per week with soft water, or 2 months, at
4hrs per week with hard water.
CHANGING THE CASSETTE
1. Purchase the replacement cassette from an authorized service dept.
2. Remove the empty cassette from the base of the iron.
3. Empty the water from the water tank and the cassette housing.
4. Place the new cassette into the housing.
5. Fill the water tank with water.
6. Cover the water filling hole.
8