Controls And Indicators; Controls; Power Switch; Mute A/B Switch (Green Led) - D&B D6 Hardware Manual

D6 Amplifier, Hardware manual

3. Controls and indicators

3.1.

Controls

3.1.1. Power switch

The power switch [1] is a rocker switch type. It does not isolate the unit
from mains power.
- OFF
The unit is switched off except the overvoltage protection circuit. The
power consumption is low (1 W typical).
- ON
The unit is switched on and ready for operation.

3.1.2. MUTE A/B switch (green LED)

When the mains power switch is set to the on position, the MUTE A/B
switches (push buttons) [2] can be used to mute the respective amplifier
channel or place the D6 in Standby mode.
Note: The setting of the MUTE A/B switch is stored in the D6 when the
mains power is turned off or disconnected. After switching on or
reconnecting the unit it will revert to its previous status.
MUTE / STANDBY
- A brief press of the MUTE (A or B) switch will mute the corresponding
channel A or B. The channel is unmuted by briefly pressing the
corresponding MUTE switch.
- A longer press (approx. 1.5 s) of MUTE A or B places the D6 in
Standby mode. Briefly pressing the MUTE A or B switch again powers
on the D6 ready for use. The D6 may also be powered back on by
remote control from Standby mode.
(1.2EN) Page 7 of 20