Table of Contents
Advertisement
D6
MAINS SUPPLY
VOLTAGE SEE LABEL
~ 50/60 Hz, 1000 W
D6
D6
MAINS SUPPLY
VOLTAGE SEE LABEL
~ 50/60 Hz, 1000 W
Fig. 2: Pin assignment ANALOG INPUT/LINK
D6 Amplifier, Hardware manual
4. Connections
OUT
OUT
A
B
4.1.
The D6 is a protective class 1 unit.
A PowerCon
D6
appropriate mains lead is supplied.
100-127V / 220-240V
ÉZ2700.000WË
Before connecting the device to mains voltage, check that the mains
Z270000000001
WEEE
voltage and frequency correspond to the specifications on the
0615
configuration sticker on the rear of the D6.
CH A
CAUTION: For any sign of obvious damage to the power cord and or
DIGITAL AES/EBU
ANALOG
OUT
OUT
A
B
REMOTE
SERVICE
CH B
mains connector the power cord must not be used and must be
exchanged before further use of the unit.
4.2.
NOTICE: To meet the EMC requirements only shielded cabling and
proper fitted connectors must be used.
4.2.1. INPUT A/B and LINK A/B
A 3 pin female XLR input connector [9] is provided for channel A and B.
The inputs are electronically balanced.
Wired in parallel is a 3 pin male XLR input link connector [10] used to
feed the input signal on to the next device in the system signal chain.
1
(1.2EN)
REMOTE
Mains Connector
WARNING!
A missing earth (ground) contact may lead to dangerous
voltages in the housing and controls and may lead to electric
shock.
- The unit must only be connected to mains voltage supply with
protective earth.
®1
mains connector [8] is fitted on the rear panel and an
Signal inputs and link outputs
®
PowerCon
is a registered trademark of the Neutrik AG, Liechtenstein
CH A
DIGITAL AES/EBU
ANALOG
SERVICE
CH B
Page 10 of 20
Advertisement
Table of Contents
