Advertisement
Step 6: Handlebar Assembly
A. Place bike upright on all four feet.
B. Align the handlebar assembly (7) with the handlebar bracket (H) on the console mast (6).
C. Feed the wire harness connector from the top of the console mast (6) through the square
hole in the middle of the handlebar assembly (7). There should be three wire connectors
coming out the top of the handbar assembly.
D. Place the handlebar assembly (7) into the handlebar bracket (H) and align with bolt holes.
Be sure to pull any slack wiring through the handlebar assembly so the wire harness
does not get pinched.
E . Install two M8 bolts (20) through the handlebar assembly (7) into the handlebar bracket (H).
F. Securely tighten bolts.
14
7
H
6
20
Advertisement
