Controlling The Unit With The Tv Remote Control; Clearing The Learning Function; Restoring All Settings To The Default Settings - Pioneer SBX-300 Operating Instructions Manual

Controlling the unit with
the TV remote control
The unit can learn TV remote control operation
to enable operation of the unit with the TV
remote control (learning function).
The following three functions can be operated
with the TV remote control.
• Volume down
• Volume up
• Power on/off (standby mode)
Note
• This function may not be supported depending on
the TV remote control. If it is not supported, use the
remote control supplied with the unit.
1 Turn off the TV.
2 Press uSTANDBY/ON on the unit to turn
off the power.
3 Press VOLUME – for at least 3 seconds
while pressing VOLUME + on the unit.
The indicators flash green and the unit
enters remote learning setting mode.
4 Press the button below corresponding
to the function to learn.
Function to
Button on unit
learn
VOLUME –
Volume down
VOLUME +
Volume up
Switch between
power on and
uSTANDBY/ON
standby
5 Press the TV remote control button
corresponding to the function to learn
while pointing the remote control sensor
toward the unit until the indicators
change from flashing green to lit.
• If learning fails, the indicators light red.
The procedure automatically returns to
step 4 so perform the operation again.
• If 10 seconds elapse with the indicators
flashing, the procedure automatically
returns to step 4.
6 Repeat steps 4 and 5 to enable the unit
to learn all three functions.
7 Press VOLUME – for at least 3 seconds
• If learning failed, perform the operation
• If the same operation is performed with
• If you use the remote control when the
• The TV remote control signals may be received by
Indicator that
flashes green

Clearing the learning function

BD/DVD
1 Press INPUT SELECT for at least 3 seconds
STB
ANALOG
TV
Restoring all settings to
the default settings
1 Press uSTANDBY/ON for at least 3
The learned TV remote control operations are
also cleared.
while pressing VOLUME + on the unit to
end remote control learning mode.
When all of the indicators turn off, release
your fingers from VOLUME + and VOLUME – .
The unit enters standby mode.
Caution
again while the power of the TV is off. The
light from the TV screen may affect remote
control learning.
a different TV remote control (or different
buttons) after learning, the old functions will
be overwritten with the new ones.
power states of the unit and TV are opposite
after the unit has learned the TV power
button, the function will not work properly. In
this case, press uSTANDBY/ON on the unit
so that the power states of the unit and TV
become the same before using the remote
control.
and operate both the TV and the unit. Set one of
the following.
– Set audio output from the built-in speakers of
the TV to OFF.
– Set the TV volume to the minimum level.
in learning mode.
The indicators flash red and the learning
function is cleared.
seconds while pressing INPUT SELECT on
the unit when the power of the unit is
on.
All indicators light red and the default
settings are restored.
Caution
Other Functions 17
En