Kenwood KHG 601 Instructions For Use Manual page 11

BURNERS AND GRIDS
• These parts can be removed and
cleaned with appropriate products.
• After cleaning, the burners and their
flame spreaders must be well dried
and correctly replaced.
• It is very important to check that the
burner flame spreader and the cap
have been correctly positioned.
• Failure to do so can cause serious
problems.
• Check that the electrode "S" (figs. 3.1 -
3.3) is always clean to ensure trouble-
free sparking.
• Check that the probe "T" (figs. 3.1
- 3.3) next to each burner is always
clean to ensure the correct operation
of the safety valves.
Both the probe and ignition plug must
be very carefully cleaned.
Note: To avoid damage to the electric
ignition do not use it when the burners
are not in place.
CORRECT REPLACEMENT OF THE AUXILIARY, SEMIRAPID AND RAPID
BURNERS
It is very important to check that the burner flame spreader "F" and the cap "C" have been
correctly positioned (see figs. 3.1 and 3.2 ).
Failure to do so can cause serious problems.
CORRECT POSITION OF THE TRIPLE RING BURNER
The triple ring burner must be correctly positioned as indicated by the arrows in fig. 3.3.
The burner correctly positioned must not rotate (fig. 3.4).
Then position the cap "A" and the ring "B" (figs. 3.4 - 3.5).
GLASS LID
(Optional)
Models with glass lid
Do not shut lid when
burner alight.
ATTENTION
Do not lower the glass lid when the
gas burners are still hot or when
the oven is working or still hot.
Do not lay on the glass lid hot pans
and heavy kitchen utensils.
Dry off any liquid whitch may have
spilt on the cover before opening it.
11