Chapter 2: Cb-1000 Setup - Calypso CB-1000 Manual

Chapter 2: CB-1000 Setup

Once serial communication is established, CB-1000 Software is used to configure and program
the CB-1000. The upper section of CB Config sets CB-1000 options and facilities IR learning,
while the lower section of the interface shows current CB-1000 settings and acknowledges each
serial command as it is executed. Using CB Config is as easy as clicking on each button and
selecting the desired option.
2.1 IR Mode
The CB-1000 can transmit either pre-programmed CIRT
codes, used when commands are sent to other Calypso
controllers, or it can learn Universal IR codes. Use button A to toggle between
Universal Learn, CIRT1 and CIRT2 modes.
2.2 Speaker On
The built-in speaker, used to play an audible click upon a button
press, can be turned on or off by toggling button B.
2.3 Clone
Clone mode may be turned on or off by toggling button C. Turning Clone On places the CB-
1000 into a parent clone mode. Accordingly, when the parent unit is connected to a 2
unit (in Clone Off mode) via the serial cable, all configuration and IR settings from the parent unit
are copied to the child unit. Both units must be powered up and the child unit will beep in
unison with the parent upon completion of cloning.
A
B
nd
child
C
Page 6