Garmin GPS 155XL Installation Manual page 30

4.3.7 Configuration
Select the Configuration Test Page. Change the selectable Strap and Fuel selections to match that of the
aircraft. The available options are:
Fuel:
Setting
av gas
jet A
jet B
The Fuel option is used to designate the type of fuel used so that the correct fuel density will be
used in calculations.
Strap:
Setting
lnav 1
lnav 2
common
The strap option affects the interpretation of ARINC 429 input data.
For ARINC 429 input data, the following applies:
Setting
Lnav 1
Lnav 2
common
4.3.8 Remote Battery Settings
Remote Battery: The two available remote battery settings are "none" and "instld".
If "instld" is selected when a battery is not installed, erroneous voltages will be shown on the
Power Test page and invalid battery messages will be issued in normal operating modes.
Low Battery—Selectable between 8.0 volts and 9.6 volts by 0.2 volt steps
In normal operating modes, the "Battery Low" message will be issued when the battery voltage is
below the low battery value. The default value is 9.0 volts.
Page 4-6
Revision F
Description
Using Aviation gas (5.8 lbs/gal)
Using Jet A/Jet A-1 fuel (6.7 lbs/gal)
Using Jet B (JP-4) fuel (6.5 lbs/gal)
NOTE
Description
Number I (Pilot) long range NAV
Number 2 (Co-Pilot) long range NAV
Common long range NAV
NOTE
Description
Only data with SDI=0 or SDI=1 is used
Only data with SDI=0 or SDI=2 is used
Only data with SDI=0 is used
NOTE
SDI=0 is an "all call".
NOTE
NOTE
GPS 155XL/GNC300 XL Installation Manual
190-00067-22