Table of Contents
Advertisement
BUSHING REMOVAL AND INSTALLATION
1. Using the 1" tap, screw it into the bushing. This will cut threads in the bushing
to fit the bushing puller (#BUPU).
2. Screw the bushing puller (#BUPU) into the bushing.
(#SHBUPU) into the bushing puller.
3. Using the slide hammer on the shaft puller, remove the bushing.
4. Drive the new bushing in with our bushing installer (BUIN) and a four to five
pound hammer.
5. After the bushing is installed, the bore will shrink. Run a 7/8" reamer or 7/8" drill
bit through the bushing to make sure that the shaft will turn freely in the bushing.
BUSHING REMOVAL AND INSTALLATION
SPECIAL ITEMS NEEDED
1
sabre saw or sawzall with blade to cut bronze
1
3/4" bolt (any length)
1. Using a saw, split the bushing at two locations. Be careful not to cut the shaft
housing. After the bushing is split, pull out the two pieces with a pair of pliers.
2. Insert a 3/4" bolt into the bushing using it as a bushing installer. Drive the
bushing in with a four or five pound hammer.
WITH OUR TOOLS
WITHOUT OUR TOOLS
Screw the shaft puller
19
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Surface Drive and is the answer not in the manual?
Questions and answers