Table of Contents
Advertisement
P
I
REPARING THE
NSTALLATION
Air Conditioner and Accessories
The following accessories are supplied with the air conditioner.
➢
The quantities are indicated in parentheses.
Accessories in the Indoor Unit Case
Accessories in the Outdoor Unit Case
➢
The flare nuts are attached to the end of each evaporator in/out pipe or service valve.
Use the nuts when connecting the pipe.
➢
The 3-wire assembly cable is depending on the option. If they are not supplied, Using the standard
cable.
➢
The rubber leg is only included when the air conditioner is supplied without the assembly piping
illustrated below.
The following connection accessories may be supplied, depending on the option. If they are not supplied,
it is recommended that you collect them together before starting to install the air conditioner.
Assembly Piping,
Ø6.35mm by 5m (1)
Pipe Clamps A (3)
➢
If these accessories are supplied, they are located in the accessory box.
6
E-
Installation Plate (1)
Batteries for
Owner's Instruction
Remote Control (2)
3-wire
Assembly Cable (1)
Assembly Piping,
Assembly Piping,
Ø9.52mm by 5m (1)
Ø12.70mm by 5m (1)
(✴✴09✴✴)
(✴✴12/14✴✴)
Pipe Clamps B (3)
M3.8 x 20 Screws
for Wood (6)
Remote Control (1)
Installation Manual (1)
Booklet (1)
Rubber Leg (4)
PE T3 Foam Tube
Insulation (1)
M4 x 16 Tapped
Screws (6)
Vinyl Tape,
Rubber Leg (4)
Width 50mm (2)
Putty 100g (1)
Drain Hose,
length 2m (1)
Advertisement
Table of Contents
