Table of Contents
Advertisement
Note: The default setting of SS is 03, which means once an object is detected
more than 3 grids, the system will get triggered. So the value of SS must be
less than the number of grids that you set up for the motion detection area.
3)
TS (Time of Sensitivity)
"TS" is to set the sensitivity regarding how long one object stays in the detection
area and triggers the recording. The smaller the value is, the higher sensitivity for
motion detection.
The highest sensitivity setting is 00, and the lowest sensitivity setting is 15. The
default setting is 02.
4)
DET
Select if you want to activate the motion detection function for the selected channel
(ON/OFF).
5)
ALARM
Select N.C./ N.O depending on your installation need. The default alarm value is
OFF.
6)
AREA
Click "EDIT" to set the motion detection area.
There are 16 × 12 grids per camera for all channels. Pink blocks represent the area
that is not being detected while the transparent blocks are the area under
detection.
5.5 PTZ Camera Setting
Right-click to display the main menu, and select "ADVANCE CONFIG"
CANERA
DETECTION
ALERT
NETWORK
SNTP
DISPLAY
RECORD
REMOTE
EXIT
1)
DEVICE
For the PTZ camera, select "PTZ".
2)
ID
Click the current value to set the ID number (0 ~ 255) for the connected PTZ
camera if necessary.
(For Selected Models Only)
ADVANCE CONFIG
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11
DEVICE
ID
PROTOCOL
RATE
23
FREQUENTLY-USED FUNCTIONS
PTZ
00
NORMAL
2400
"REMOTE".
Advertisement
Table of Contents
