DigiSender Plug’n’Go DX200-LCDRX Instruction Manual page 2

DX200-LCDRX - DigiSender® Plug'n'Go™ LCD
Step 1: Install the Accessory Receiver
The Plug'n'Go™ LCD Accessory Receiver will pick up the signals being sent by your Plug'n'Go™ LCD
Transmitter and output them to a connected TV.
1.
Locate a vacant SCART socket on the back of your
receiving TV and insert the DigiSender® SCART
cable.
3.
Press and hold the power button for 5 seconds to
turn the Receiver on. Pressing the button again
cycles through the 4 available channels. Make sure
it is set to the same channel as the Transmitter.
Page 02
2.
Connect the Receiver into a Mains Extension
Lead. The positioning of the Receiver can affect
the picture quality so being able to move it is an
advantage.
4.
Position the IR Sensor on the top, side or bot-
tom of your receiving TV with the lens facing
out into the room.
Please read this instruction manual carefully prior to installation