proAxis nightingale Quick User Manual

Quick User Guide
First Use - Installation
Ensure all connections are secure. Check the handset and power
supply cables are connected, located at the head end of ProAxis.
Turning Off: Power off ProAxis by pressing the Bed Up and Bed
Down buttons simultaneously for 10 seconds. They stop flashing
when off. Ensure power supply is disconnected to turn off.
NOTE: If the power supply is not connected, the red LED will flash
constantly at the foot end of ProAxis on the right. If the handset is
not connected, the red LED will flash every 6 seconds.
Please ensure ProAxis has at least 4 inches clearance from the
wall.
Main Functions - Handset
ProAxis moves via a patient / nurse handset. The vertical height of
the bed, the backrest and footrest can all be altered higher or
lower using the patient / nurse handset.
Two preset buttons are located at the bottom of the handset,
which are preset chair and preset flat positions.
Lockout Controls, CPR and Trendelenburg
The lockout box, located under the dropping hinge, can lockout
functions on the patient / nurse handset.
Pressing the two red CPR buttons simultaneously or within 2
seconds of each other can operate CPR.
Trendelenburg tilt is available both ways using the green
buttons.
Smart Control/Weight Indicator
The Smart Control/Weight Indicator is programmed using the
menu keys, which are the blue buttons under the screen. Options
displayed in the menu bar at the bottom of the screen correlate
with the blue buttons directly underneath.
1/2
ProAxis Quick User Guide 2.1 Date 18/05/11