Table of Contents
Advertisement
Lighting Rod Light the Main Burners:
1.
Remove cooking grid from burner you desired to light.
2.
Dip the end of lighting rod into flamable liquid as kerosene then light it. Once lit, place the flame through the hole as shown near the burner ports.
3.
Press in valve knob and rotate counter clockwise to Hi setting and burner should light immediately. If more than one burner is desired, repeat
procedure with each burner.
4.
Replace cooking grid and adjust burners to desired cooking settings.
Option-Left and right main burners can be lit by inserting a lit match attached to the end of the Lighting Rod through holes on
either side as desired.
After lighting, please observe the burner flame, make sure all burner ports are lighted.
If burner flame goes out during operation, immediately turn the gas "off" and open lid to let the gas clear for about 5 minutes before re-lighting.
Before cooking on this grill for the first time, operate the grill for about 15 minutes with the lid closed and the gas turned on "high." This will "heat clean"
the internal parts and dissipate odor from the manufacturing processes and painted finish.
Clean your grill after each use, DO NOT use abrasive or flammable cleaners, as it will damage the parts of this product and may start a fire.
1. Open lid during lighting burner. Lid must be open when burner is on.
2. Valve must be in the "off" position
3. Open cylinder valve.
4. Push in side burner valve knob fully and rotate slowly about 1/4 turn counter-clockwise until a click is heard and this will light the burner. If the burner
does not light, immediately return the valve knob to OFF, wait five minutes for the gas to clear and repeat the procedure.
5. After burner ignites, adjust valve knob to desired cooking setting.
Shutting Off Burners
1.
Always turn the valve knob(s) clockwise to the High position, then depress and turn it to OFF.
Never force the knob without depressing it as that can damage the valve.
2.
Promptly turn the gas supply OFF at the propane cylinder.
3.
Close the lid of the grill.
2"
1"
0"
Caution: All cleaning and maintenance should be done when grill is cool and with the fuel supply turned off at the control dial and the propane cylinder
disconnected. DO NOT clean any grill part in a self cleaning oven. The extreme heat will damage the finish.
Cleaning
Burning-off the grill after every use (approx. 15 minutes) will keep excessive food residue from building up.
Recommended cleaning materials -
Mild dishwashing liquid detergent
Nylon cleaning pad
Paper clip
Compressed air
DO NOT use cleaners that contain acid, mineral spirits or xylene.
GSF2616J owner's manual
Side Burner
:
5cm
2.5cm
0cm
Cleaning and Care
Hot water
Wire brush
Putty knife/scraper
Observe Flame Height When lit:
Flame should be a Blue / Yellow color Between1"– 2" High
15
GSF2616J Gas Grill
Advertisement
Table of Contents
