Halex Titan BTX Owner's Manual page 3

Titan BTX Electronic Dartboard _ 3
Setup / Mounting Instructions
Choose a location to hang the dartboard where there is about 10 feet of open space in front
of the board. The "toe-line" should be 7' 9 1/4" from the face of the dartboard. Since this
dartboard is powered with an AC adapter, you may want to mount it close to an electric
outlet for convenience.
Mount the dart board into the screw receivers of the cabinet using the screws provided.
The mounting brackets on this cabinet set are 16" apart so it can be mounted securely on
wall studs in your home. Locate a wall stud and place a mark 84.5" from the floor. Measure
16" from your first mark (staying level with the first mark) and place the second mark on the
wall, which should be over another wall stud (refer to diagram on next page).
Screw 2 mounting screws in the center of the studs using the marks you made as guides.
Be sure the screws are level to ensure an accurate playing surface. If not mounting into
studs, be sure to use drywall anchors or other securing hardware appropriate to the wall you
are using. This dartboard cabinet is heavy and it is highly recommended that you mount it
to wall studs.
Mount the cabinet on the wall by lining up the hang brackets on the back of the cabinet with
the screws (see diagram below). It may be necessary to adjust the screws until the board
fits snugly against the wall.
16"
Hang Brackets
Screw Receivers