M16 Specifications - Cadac M16 Installation & User Manual

M16 Specifications

NOTE: 0dB = 0.775V RMS without reference to impedance. Unless otherwise stated, all specifications given below apply
to the frequency range 20Hz to 20kHz. All noise measurements are RMS and made with a DIN audio band filter (–3dB
points at 22Hz and 22kHz) in circuit.
Microphone Input
Input impedance
Maximum input level (10dB gain with PAD out)
Maximum input level (20dB gain with PAD in)
CMRR
Signal to noise: (10Hz-20kHz)
Dynamic range:
Frequency response: (10dB Gain, 200 ohm source)
Gain range:
Equivalent input noise with 200 ohms source impedance (DIN bandwidth)
Total harmonic distortion, gain set at +10dB
Crosstalk: (10dB gain, input level 0dBu)
Phantom power
High Pass filter
–3dB frequency
Slope
Analogue outputs (all outputs are electronically balanced)
Impedance:
Nominal load impedance:
Nominal output level:
Max output level:
Output balance:
Digital output
Protocol:
Format:
Sample rate:
Synchronization:
Connectors
Analogue inputs:
Analogue outputs:
PFL In:
PFL Out:
MADI Output:
Remote In:
Remote Out:
Computer Interface:
Revision MA2005-7
Measured with gain at 60dB
Measured with gain at 10dB
Operational modes
1k2
+21dBu
+21dBu
better than 100dB
–97dBu at 10dB gain
–67dBu at 60dB gain
120dB
10Hz to 100kHz ±0dB
10dB to 60dB
–127dB
–107dB
0.003% (1kHz)
–80dB at 10kHz
+48VDC, 14mA (per channel)
60Hz
–12dB per octave
33 ohm in series with 1000uF
(balanced)
600 ohms
0 dBu
+22.5dBu into 600 ohms
>70dB (10Hz to 20kHz)
MADI (Multi-channel Audio Digital Interface)
Compliant to AES-10-2003
56 channel at 48kHz (±12.5% varispeed)
28 channel at 96kHz (±12.5% varispeed)
64 channel at 48kHz
32 channel at 96kHz
Word clock (selectable Internal/External)
Duty cycle 50% (TTL level)
Termination BNC, 75 ohms impedance
16 x XLR-3F (pin 2 hot)
Split 1: 16 x XLR-3M
Split 2: 37-way Dsub
Split 3: 37-way Dsub
1/4" TRS Jack (balanced)
1/4" TRS Jack (balanced)
SC Duplex
XLR3F, RS-485
XLR3M, RS-485
USB Type B downstream
SPEC-1
M16 Microphone Amplifier