Related Manuals for Mvac Central vacuum system
Summary of Contents for Mvac Central vacuum system
- Page 1 Owner’s Manual For housEhold usE only Please read this document carefully before installing and/or using your vacuum cleaning system. Model: ______________________ Serial no: ________________________...
-
Page 2: Important Safety Instructions
Important Safety InStructIonS When using an electrical appliance, basic precautions should always be followed, including the following. read all instructions before using this appliance WarnInG – To reduce the risk of fire, electric shock, or injury: 1. Do not leave appliance when plugged in. unplug from outlet when not in use and before servicing. -
Page 3: Table Of Contents
Maintenance – Other models – with bag Maintenance – Other models – without bag troubleshootIng General Information Decrease in suction strength Vacuum will not start Vacuum will not stop Warranty InformatIon Limited Lifetime Warranty One Year Satisfaction Guarantee Warranty on Mvac Attachments WEEE Directive... -
Page 4: Preface
4. Low Voltage Connector extensive network of qualified professionals ensures first quality service near you. 5. Serial Number Contact us for the location of the Mvac authorized service center in your area. 6. Air Intake 7. Air Exhaust 8. Muffler (optional) min. -
Page 5: Installation
2 centers. Contrary to all other connections in the piping system, do not glue the last fitting to your unit. Mvac central vacuums are equipped with an adjustable air intake valve (figure 3), which does not require glue. An air- tight fit is achieved with the screw-type adjustment on the fitting itself. - Page 6 dOs & dOn’Ts dOs & dOn’Ts InstallIng Inlets When installing your vacuum inlets, we recommend that the principle of electric polarity be taken into account. Ensure that the wire connected onto contact A on inlet 1 is the same as that connected to contact A on inlet 2, and so on. Do not cross, reverse or interchange wires.
-
Page 7: Muffler Installation (Optional)
Muffler insTallaTiOn eleCTriC COnneCTiOns (OPTiOnal) 1. Insert the rubber coupling (A) on the air exhaust (D). There should be an electric outlet within 1 meter (3 feet) of your central vacuum unit. Once the appliance is installed in a suitable location, connect your 2. -
Page 8: Grounding Instructions
GrOundinG insTruCTiOns lOw VOlTaGe COnneCTiOns This appliance must be grounded. If it should malfunction or breakdown, Connect the low voltage wires to the low grounding provides a path of least resistance for electric current to reduce voltage inlet on your unit. To do so, simply the risk of electric shock. -
Page 9: Converting The Vacuum Unit
VOlTaGe COnneCTiOns COnVerTinG The VaCuuM uniT “easy clIp” Inlets only Your Mvac central vacuum unit (except M4 model) was designed for use with or stranded Wires without disposable bag. Though it is sold with a bag installed, it can easily be removed, and... -
Page 10: Operating Instructions
& inleTs MVaC aTTaChMenTs oval dusting Brush before operatIng your central Vacuum… Please verify that it is properly connected to the piping system, and to a Use just about anywhere: on grounded electrical outlet, and that the low voltage wires are connected to the lamps &... -
Page 11: Maintenance Suggestions Module
MVaC aTTaChMenTs MainTenanCe suGGesTiOns MOdule (M9, M10, M11 and M12 Models) Hose Holder In addition to conveniently Your unit is equipped with an holding your hose, it’s specially electronic timing board that will designed to allow the storage of suggest, by the color of the blinking... -
Page 12: Motor
MOTOr MainTenanCe – OTher MOdels Please note that Mvac motors do not require lubrication. Each motor use WIth bag contains two carbon brushes which will wear normally, and may eventually Part Number: TDSAC43M Change the bag when the one in place is require replacement. -
Page 13: General Information
Mvac or Trovac parts. • Wait a few seconds for the dust to settle before removing the plastic bag. -
Page 14: Decrease In Suction Strength
TrOubleshOOTinG TrOubleshOOTinG roblem ossIble cause orrectIVe actIon roblem ossIble cause orrectIVe actIon decrease in suction Dirt recipient / Bag is Empty dirt recipient / decrease in suction Obstruction in the Remove the screw from strength full change bag (see page 22 strength (cont.) piping system the air intake connector,... -
Page 15: Vacuum Will Not Start
TrOubleshOOTinG TrOubleshOOTinG roblem ossIble cause orrectIVe actIon roblem ossIble cause orrectIVe actIon Ensure that the Vacuum will not start The electrical power is Vacuum will not stop Hose improperly Ensure that the hose power cord is plugged not connected properly inserted into vacuum end is properly placed into a dedicated... -
Page 16: Warranty Information
5 year period. Our authorized service center will repair or replace (at Mvac’s discretion) the defective part or parts, free of labor costs, for a period of **Your Mvac recommended attachments are clearly identified by a Mvac logo. -
Page 17: Weee Directive
weee direCTiVe IMpoRTAnT enVIRonMenTAl InFoRMATIon – eURopeAn eConoMIC AReA only This appliance has been assessed in accordance with the European Parliament Directive on Waste Electrical and Electronic Equipment, usually referred to as the WEEE Directive. The WEEE Directive requires that the appliance be disposed of at the end of its useful life in an environmentally responsible manner. - Page 18 Head Office / Siège social / Oficina Central Canada , rue marcel-ayotte Blainville (Québec) J7c 5L7 Tel. : (450) 434-2233 • Fax : (450) 434-6111 info@trovac.com 1 888 77cycLo distribution Centers / Centres de distribution / Centros de distribución...