Electrical Safety Information WARNING ! THIS APPLIANCE MUST BE EARTHED. IF THE MAINS LEAD OF THE APPLIANCE CONNECTION TO A REWIREABLE PLUG IS FITTED WITH A PLUG: If the fitted plug is not suitable for your socket FUSE REPLACEMENT outlet, then it should be cut off and disposed of in order to avoid a possible shock hazard should it If the mains lead of this appliance is fitted with a be inserted into a 13A socket elsewhere.
Cautions Disposal of your old appliance Before disposing of an old appliance, please make sure it’s inoperative and safe. Unplug the appliance and remove or destroy all of the springs, latches, or bolt-locks in order to avoid the risk of child entrapment. It must be noted that the refrigeration system contains insulating gases and refrigerants, which require specialised waste disposal.
Cautions *Connection and installation of the appliance are to be carried out in strict compliance with the relative instructions set forth in the User’s Guide. *For the purpose of safety, the appliance must be properly grounded in accordance with specifications. *Always remember to unplug the appliance before cleaning.To disconnect the appliance, pull at the plug itself not the cord.
Page 14
Reversing The Door Swing Should you wish to reverse the direction in which the door opens (i.e.; from left to right or right to left) please follow the instructions detailed below. Never attempt to reverse the door opening by turning the door upside down. The existing / new hinges (depending on model) must always be moved to the opposite side of the door as shown above.
Page 15
Installing the decor door panel The mounting bracket, adjusting pins and cover trim which are required to install the décor door are fitted to the outside of the appliance door during transportation (see Figure A). To remove these parts: • Open the appliance door •...
Installing under the worktop • The appliance can be installed into a niche with a height between 820-870mm. The height of the appliance can be increased by adjusting the feet using a 30mm open-ended spanner as shown in Figure D. •...
Page 17
Final adjustments to the décor door panel Once the appliance is in its final location, it may be necessary to make some minor adjustments to the decor door to ensure correct alignment. If necessary: • Loosen the locking nuts • Adjust the height of the adjusting pins Y as required to a maximum of + or – 3.5mm as shown in Figure D2 overleaf.