Figure 38
Pump
assembly
Tube #1
Rubber
elbows(3)
14. Connect the condensate pump to the ICR
relay of the terminal of the board as shown
in fig 39. Make sure to fasten the pump
wire through the wire clip on the back side
of the control barrier as shown in fig. 40
g
Figure 39
Copyright ©2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
Spraying
Tube
Tube #2
BL
BL
15. Assembly the unit back following the
reverse order of disassembly.
NOTE: All tube should be inserted into rubber
elbows by at least 1/2 inch
Figure 40
- 28 -
LGE Internal Use Only