D-Link NetDefend DFL-210 User Manual page 295

Database Console Commands
gw-world:/>
Querying Update Status
To get the status of IDP updates use the command:
gw-world:/>
To get the status of AV updates:
gw-world:/>
Querying Server Status
To get the status of the D-Link network servers use the command:
gw-world:/>
Deleting Local Databases
Some technical problem in the operation of either IDP or the Anti-Virus modules may be resolved
by deleting the database and reloading. For IDP this is done with the command
gw-world:/>
To remove the Anti-Virus database, use the command:
gw-world:/>
Once removed, the entire system should be rebooted and a database update initiated. Removing the
database is also recommended if either IDP or Anti-Virus is not used for longer periods of time.
updatecenter -update Antivirus
updatecenter -status IDP
updatecenter -status Antivirus
updatecenter -servers
removedb IDP
removedb Antivirus
Note
Anti-Virus database updates require a couple of seconds to be optimized once an up-
date is downloaded. This will cause the firewall to momentarily pause in its operation.
It can therefore be best to set the timing of updates to be at times of low traffic, such as
in the early hours of the morning. Deleting a database can cause a similar pause in
operation.
Appendix A. Subscribing to Security Up-
282
dates