Panasonic CS-E7MKR Operating Instructions Manual page 7

6
TO ENJOY CLEAN & FRESH AIR
• PATROL operation detects air
quality; e-ion operation activates
when air quality is at dirty level.
• When e-ion operation activates, it
generates negative ions to produce fresh
air effect and attract dust which will then
be captured at the positively charged e-ion
fi lters.
• PATROL operation can be activated even when the
unit is turned off. When e-ion operation activates in this
condition, fan speed and air swing can not be adjusted.
• PATROL starts automatically with the unit switched on
OFF/ON
with .
7
TO IMPROVE HUMIDITY AND MOISTURE LEVEL
• This operation reduces air dryness and provides you with
a comfortable living environment during COOL mode only.
• When vertical airfl ow direction is set to AUTO, it stops at
lower position to avoid cold air contact. However, you can
adjust the louver direction manually.
TO SWITCH BETWEEN
8
POWERFUL & QUIET
POWERFUL
POWERFUL/
QUIET
TO REACH TEMPERATURE QUICKLY
POWERFUL
• This operation will stop automatically after
4 hours.
TO ENJOY QUIET OPERATION
QUIET
• This operation reduces airfl ow noises.
• When this operation is activated, the
indicator brightness will be dimmed.
COMFORT
POWERFUL/QUIET
PATROL , ,
• Can be activated in all modes and can be cancelled by
pressing the respective button again.
F568133-YS0311-0_1EN.indd 7 F568133-YS0311-0_1EN.indd 7
PATROL
POWERFUL/QUIET
QUIET NORMAL
AUTO
,
TO MONITOR HUMAN PRESENCE &
9 10
ACTIVITY FOR ENERGY SAVING &
COMFORT
To optimize energy
saving
AUTO
To maximize comfort
COMFORT
• When either operation is activated, the unit will start
to initialize for approximately 1 minute. Human activity
indicator is blinking in sequence.
• After initialization, the human activity sensor will start
to detect the level of heat source & movement, the unit
adjusts the temperature and airfl ow to keep you comfort
consistently.
Heat Source & Movement
Cool/Dry Mode
Set Temperature
Set Fan Speed
Heat Mode
Set Temperature
Set Fan Speed
* For first 15 minutes or until set temperature is reached.
• Human activity sensor will also scan for area of heat
source and movement in a room.
Human activity indicator Heat source & movement
• The unit will determine the heat source & movement
hotspot, and automatically adjust horizontal airfl ow
direction louver either fi x at predetermined position or
swing left/right.
Detection area (top view)
7m
120º
• When manual AIR SWING
and AUTO COMFORT operation will be cancel.
• Sensor may not detect moving objects further than 7m
away or beyond detection angle.
• Sensor sensitivity is infl uenced by indoor unit location,
movement speed, temperature range, etc.
• The sensor may mistakenly detects pets, sunlight, certain
lighting, fl uttering curtains and light refl ection as human
being.
NOTES NOTES
AUTO
COMFORT
POWERFUL/QUIET
,
• Cannot be selected at the same time.
• Cannot be activated during "MILD DRY COOLING"
operation is activated.
AUTO COMFORT
Low High Normal None
+1°C
-1°C
+1 tap*
≤ Medium
+1 tap
+0.3°C
-2°C
At left area of the room
At right area of the room
At centre area or multiple areas
of the room.
is selected, the ECONAVI
,
07-Jun-11 9:59:07 AM 07-Jun-11 9:59:07 AM
+2°C
Fan
-2°C
7