Fleetwood Southwind Owner's Manual page 48

On The Road
a. Type 1 Headlamps: The projected beam
should be centered vertically and horizon-
tally on the vertical surface as marked in
step 6 and 7.
b. Type 2 Headlamps: The top edge of the
projected beam is to even with a horizontal
line parallel to a line formed by the two
headlamp filament centers and to the right
of the vertical centerline of each headlamp.
9. If the headlamps do not meet the align-
05-22
ment criteria adjust the "Vertical "and/or
"Horizontal" positioning as shown on the
attached figure, rotate the knobs and/or
screws on the headlamp. When turning the
knobs and/or screws watch the direction in
which the projected beam moves to help
understand which direction on the beam
moves in relation to turning each.
10. Remember, this procedure is only a
guideline and is not a substitute for having
headlamps professionally aligned.