Advertisement
♦
In the event of serious operating problem, stop using the unit immediately. Never try to
repair the unit by yourself. Repairs carried out by unskilled people can lead to damage
or malfunction. Please contact the nearest authorized technical assistance center.
Always use the same type spare parts.
♦
Don't connect the device to any dimmer pack or power pack.
♦
Do not touch any wire during operation as high voltage might be causing electric
shock.
.
Warning
♦
To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or
moisture.
♦
Never touch bulb with bare fingers as it is very hot after using.
♦
Hot lamp explosion hazard. Do not open the unit within five minutes after switching off.
♦
Do not start on the unit without bulb enclosure or housing are damaged.
♦
The housing, the lenses, or the ultraviolet filter must be replaced if they are visibly
damaged.
♦
Do not look directly at the light while the bulb is on.
Caution
There are no user serviceable parts inside the unit. Do not open the housing or attempt
any repairs yourself. In the unlikely event your unit may require service, please contact
your nearest dealer.
Rigging the fixtures
The unit should be mounted via its screw holes on the bracket. Always ensure that the
unit is firmly fixed to avoid vibration and slipping while operating. Always ensure that the
structure to which you are attaching the unit is secure and is able to support a weight of
10 times of the unit's weight. Also always use a safety cable that can hold 12 times of the
weight of the unit when installing the fixture.
The installation must be carried out by qualified service people only. The device should
be installed out of reach of people and outside areas where persons may walk by or be
seated.
3-
3. Description
1. Optical lens with manual focus adjustment.
2. Hanging bracket with 2 knobs on both sides to fasten the unit and a mounting hole to fix a
mounting hook.
3. Mains input with CIE socket and integrated fuse holder, connect the supplied mains cable
here.
4. Lamp compartment, to be opened with this knob
5. Internal microphone
6. ¼" jack used to connect the optional CA-8 controller.
7. Two 3.5mm stereo jacks used to synchronize several units.
8. Cooling fan.
4. Operation and Technical Specification
• Plugging into the mains power, the fixture starts running.
The ME2602-1 runs in automatic or sound activated mode.
• Precise optics with special gobo / color wheel.
• Linkable by using stereo cable with 3.5mm stereo
jack ( optional )
• Focus adjustable and fan cooled.
• With easy controller CA-8 ( Optional ) for many lighting shows as listed below.
Stand by Blackout the unit
Speed of gobo wheel
Speed of gobo wheel
and mirrored-tunnel:
and mirrored-tunnel:
Function
Fast and slow
Fast and slow
Sound
Auto
Mode
(LED off )
(LED on)
a.) Adjust gobo wheel rotating
direction and speed.
b.) Adjust mirrored-tunnel
rotating direction and speed.
Latch
(LED blinking)
4-
Advertisement
