Advertisement
Specification:
• Voltage: AC 120V~60Hz
• Fuse: 20mm glass 250V T6.3A
• Bulb: ELC 24V 250W
• Dimension: 306 x 263 x 140 mm
• Weight: 8 kgs
5. Lamp installation or replacement
• Always switch off the mains supply and never handle the lamp or luminaire when it is hot.
• Do not touch the bulb with bare hands. If this does happen, clean the lamp with denatured
alcohol and wipe with a lint free cloth before installing.
6. Beam angle
The Projector is best to be placed 5 meters from wall, and from this distance the light effect
will cover an area of 3.7 m x 3.7 m.
Pull the socket off the lamp.
Do not pull the wires.
5-
1. Introduction
Thank you for purchasing Wild Tech's ME2602-1. It is a unique 250W kaleidoscopic effect
that projects a swarm of swirling patterns. Comes with great built-in programs with auto
movement or sound activation. It's linkable, performing synchronized light show, perfect for
discos, clubs, bars, and parties.
2. Safety Instruction
Please read carefully the instruction, which includes important information
about the installation, usage and maintenance.
WARNING
♦
Please keep this User Guide for future consultation. If you sell the unit to another user,
be sure that they also receive this instruction booklet.
♦
Unpack and check carefully there is no transportation damage before using the unit.
♦
Before operating, ensure that the voltage and frequency of power supply match the
power requirements of the unit.
♦
It's important to ground the yellow/green conductor to earth in order to avoid electric
shock.
♦
The unit is for indoor use only. Use only in a dry location.
♦
The unit must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces. Be sure that no ventilation slots are blocked.
♦
Disconnect mains power before fuse/lamp replacement or servicing.
♦
Replace fuse/lamp only with the same type.
♦
Make sure there is no flammable materials close to the unit while operating as it is fire
hazard.
♦
Use safety cable when fixes this unit.
♦
Maximum ambient temperature is TA: 40℃. Don't operate it where the temperature is
higher than this.
♦
Unit surface temperature may reach up to 85℃. Don't touch the housing bare-hand
during its operation. Turn off the power and allow about 15 minutes for the unit to cool
down before replacing bulb or serving.
2-
Advertisement
