Y240A200M202
REV.-=--
THE SINGER COMPANY
KEARFOTT DIVISION
3.1.3 . Manually entered bootstrap.
If ROM is not available and if the bootstrap loader (see section 3.5.3) has not been previously
placed into memory it must be manually entered.
For some applications the SKC2000 hardware includes a system configuration in which a PDP11
minicomputer is connected to the CCU and acts as a front end to the SKC-2000 for peripheral
devices connected to the PDP11. The hardware and PDP11 software have been constructed so that
they are transparent to the user in regard to operating the CCU. The use of the PDPll is not further
described herein.
3.2 START UP FLOWCHART
The hardware and operational decisions that determine start up procedures are summarized in a
flowchart,figure 3-1.
3.3 POWER UP PROCEDURES
The following CCU switch settings are used for start up
•
RUN/STOP - STOP
•
PANE L RUN - ON
•
MEM/PANEL INST - PANEL
•
MEM/PANEL OPER - PANEL
•
ADDR COMP MODE - OFF
•
HALT- ON
•
PROGRAM SWITCHES - All Down
Then:
•
Turn CCU Power Switch - ON
•
Turn on SKC2000 at power source (installation dependant)
•
Depress Reset Master
3-2
F4202·1
2/72