Removing An Optical Drive - Dell OptiPlex 745c User Manual

1 floppy drive 2 shoulder screws (4)
4. Attach the power and data cables to the floppy drive.
1 power cable 2 data cable
5. Replace the computer cover (see
6. Enter system setup (see Entering System
7. Verify that your computer works correctly by running the Dell Diagnostics (see
Optical Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before replacing the cover.

Removing an Optical Drive

1. Follow the procedures in Before You
2. Disconnect the power and data cables from the back of the drive.
3. Grasp the sliding plate lever and slide it towards the top of the computer until the drive panel snaps open; while holding the lever in place, slide the
drive out of the computer.
3 shoulder screw slots (2)
3 floppy-drive connector (DSKT)
Replacing the Computer Cover).
Setup), and use the Diskette Drive option to enable your new floppy drive.
Begin.
Dell Diagnostics).