Operation - INFOSEC Eco PowerGuard TFR User Manual

OPERATION

 Plug the power cord into AC power source.
Caution: Make sure the operating voltage of Eco PowerGuard TFR is correct before connecting it to
AC power source.
The current display panel flashes once and the Surge Protection, Grounding, and Permanently‐On
LED lights come on.
Note: For the moment remote‐controlled outlets are still off.
 Use one of your IR remote to turn on Eco PowerGuard TFR. The current display panel and Power
LED will be turned on.
Note:
1. Eco PowerGuard TFR has a limited reception frequency range as described in the Electrical
section of the Specifications. Please contact the electrical appliance service agency if your remote
does not turn on Eco PowerGuard TFR.
2. Any function key of an IR remote control should enable the Eco PowerGuard TFR unit.
3. The Eco PowerGuard TFR product cannot be turned off ‐ the power cord has to be unplugged
from the AC power source.
4. The IR LED will flash once when the signal is received.
 The remote‐controlled outlets supply now the power to the connected electrical appliances.
Turn on the connected electrical appliances.
Note: The current display will show the total current consumption for all remote‐controlled outlets
only.
 Turn your appliances off with the usual remote control. Eco PowerGuard TFR will automatically
detect a variation of the total power consumption. If the total power consumption falls below 70%
of the peak current load, after 3 minutes Eco PowerGuard TFR shuts down and switches to standby
mode.
Note:
1. Please see shutdown conditions in the specifications for details.
2. Only the remote‐controlled outlets will go off (permanently‐on outlets are remain on).
 Repeat Step 3 to turn on the connected electrical appliances again once the Eco PowerGuard
TFR has switched to standby mode.
INFOSEC UPS SYSTEM – 4 rue de la Rigotière – 44700 Orvault – France – www.infosec-ups.com
Hot Line Tel: +33 (0)2 40 76 15 82 – fax: +33(0)2 40 94 29 51 – hotline@infosec.fr – 06 09 AA 08 204 26
19