Advertisement
Place the system on the table, check to see if there is any ink in each of the air
balance tube. If yes, you need to remove the ink in the balance tubes by the following
steps:
1) Pull sealed plug out (3-1-1).
2) Use the injector to draw ink.
3) Put the sealed plug back.
4) Pull out the in refill plug.
5) Inject the ink in the injector into the ink holding tank according to its color.
6) Put the ink refill plug back.
7) Check all the plugs to make sure they are completely sealed.
2. Replace air balance plugs
Put this system on the right side of printer, tidy up ink flow tubes, pull out an air
balance plug and replace it with an air filter with the bigger side downwards. This is
repeated for each air balance plug. Keep the air balance plugs for future use.
Move out cartridge holder
Press ink button (3-2-1). Move cartridge holder to the cartridge, changing
position (3-2-2), pull the printer power off (3-2-3).
Pic. 3-2-1
3. Move out cartridges
Insert screwdriver like (3-3-1), screw screwdriver like (3-3-2) until take cartridge
cover off
INSTALLATION MANUAL ON CISS FOR PRINTER EPSON C41/C46/C45/C44/C43/
Pic. 3-1-1
C42/C41/C40/C20/480/580
Pic. 3-1-2
Pic. 3-2-2
Pic. 3-2-3
3
Advertisement
