Simple Recording - JVC HR-VP472U Instructions Manual

Simple
Recording
Turn on the TV and select the VCR channel 3 or 4 (or AV
mode).
[VP672U]
[VP472U]
1
4
NUMBER
7
1
PLAY
REC
CH
CH
2 3
2
5 6
8 9
0
4
CH+/–
SP/EP
PAUSE
LOAD A CASSETTE
1
Make sure the record safety tab is intact. If not, cover the
hole with adhesive tape before inserting the cassette.
SELECT RECORDING
CHANNEL
2
Press CH5 ∞ (+/–) . Or press the appropriate NUMBER
keys, then press ENTER. (The channel changes after a
few seconds whether you press ENTER or not.)
If you use the RF connection, by pressing the TV/VCR
button, select VCR mode to view the program to be
recorded.
SET TAPE SPEED
3
Press SP/EP to set the recording speed.
START RECORDING
4
Press and hold REC and press PLAY on the remote
control, or press REC on the VCR's front panel.
Video Calibration takes places at the beginning of both
the first SP and the first EP recording after inserting the
cassette (when video calibration is set to "ON"
26).
PAUSE/RESUME
RECORDING
5
Press PAUSE. Press PLAY to resume recording.
During record pause, you can change the recording
channel by using the CH5 ∞ (+/–) buttons or NUMBER
keys.
Video Calibration will not take place if the tape speed
is changed while in record pause mode.
STOP RECORDING
6
Press STOP or STOP/EJECT. Then press STOP/EJECT to
remove the cassette.
Accidental erasure prevention
To prevent accidental recording on a recorded cassette,
remove its record safety tab.
To record on it later, cover the hole with adhesive tape.
17
EN
pg.
Record safety tab