Pioneer CLD-A1CC Service Manual page 67

CLC-AIOO
• Player Operation Modes
MODE 1 OPEN MODE
3
STOP
St.
o eration St.
o eratlon
0
Clears internal registers, sets the spindle to
STOP
and wails for focus OFF.
0
Clears internal registers , sets the spindle to STOP
and waits for locus OFF.
Double side
Single side
Double side Sinole side
t
Side B
Side
A Durina a turn
t
Side B
SdeA
Ourino a-turn
Starts tilt up
Starts tilt down
Starts till UD
Starts bit down
Wait for tilt up. Wail for
lilt
up.
2 Starts to move the slider B to
2
Starts to move the Slider 8 to
the oul side. the out side.
3
Waits for the spindle to stop. 3 Waits for the spindle to stop.
4
Waits for the slider B to move
4
Waits for the slider 8 to move
the out side. the out side.
S Starts clamp switching (8 to A). S Starts clamp switching (8
to
A).
6
Waits for clamp switching (8 to A).
6 Waits for clamp switching (8 to A).
7 Starts till down. 7 Starts tilt down.
8 Wait for tilt down
8 Wait for \ilt down
9 Starts to
move
the slider to the LD sensing position.
A
Waits for the spindle to stop.
Starts to move the slider to the LO
9
sensing pOsition.
B Waits for the slider to reach the LD sensing position.
A Waits for the spindle to stop.
C
Starts unloading.
B Waits for the slider to reach the LD sensing position.
0 Perf()(ms unloading until the OUT SW activates.
C Starts to move the tilt 1 0 the neutral position.
E Sets the lOOms timer.
0
I
F Wails for 100 ms,
E
Waits fot the
tilt
to reach the neutral position.
to
Sets the OPEN mode.
Completed
Completed
MODE 2 STANDBY
Slep
Operation
0
Clears internal registers, sets the
spindle to STOP
and waits for focus OFF.
Double side Sin Ie side
t Side B
SdeA
During a -turn
Starts tilt up Starts ti lt down
Wait for \ilt up.
2 Starts to move the slider B to
the out side.
3 Waits lor the spindle to stop.
4
Waits lor the slider 8 to move
the out side.
S Starts clamp switching (8 to A).
6 Waits for clamp switching (8 to A) .
7 Starts tilt down.
8
Wait/or bit down
9 Starts to move the slider to the LD sensing position.
A Waits for the spindle to stop.
B
Waits for the slider to reach the LD sensing position.
C
Starts 10 move the WI to the neutral posibon.
0 Waits for the tilt to reach the neutral positon.
Completed
86