Vdisk.sys; Xfer.exe - Falcon DOS Portable Data Terminals Advanced User's Manual

System Utilities

VDISK.SYS

This driver configures some of the unit's available random access memory
(RAM) as a read/write disk, called a RAM disk. This driver is located on Drive
B of the Falcon unit and is loaded using the config.sys file located on that
drive. On 31x models, all of the Extended Memory on the unit (either 1 or 3
MB) is used to create a single disk (Drive D). On all other models, only the first
1MB of Extended Memory is used to create Drive D. The remaining available
Extended Memory may be used to create additional RAM disks.
Syntax
DEVICE =
VDISK.SYS [disk_size [sector_size [root_entries]]]
Options
disk_size
Specifies the size of the RAM disk in kilobytes. The default disk size is 64 KB.
If the amount of available Extended Memory is less than the disk size specified
here, the size of the disk will be adjusted to the largest size available.
sector_size
Specifies the disk sector size in bytes. The default sector size is 512 bytes.
Possible values are 128, 256, or 512.
root_entries
Specifies the number of root directory entries. The default value is 64 directory
entries. This number may be set to any value between 2 and 1024.

XFER.EXE

The XFER utility provides the ability to transfer files to and from a PC through
the Falcon's serial port. For basic information about XFER, refer to
through
6-8
. For complete information, refer to
page 1-12 Chapter 3
®
Falcon DOS Portable Terminals
page 1-11
.