JVC HR-S8850EU Instructions Manual page 59

DIGITAL TBC/NR
8
ON
OFF
B.E.S.T.
8
ON
OFF
PICTURE CONTROL
8
AUTO: Provides the optimised
picture benefits of the B.E.S.T.
Picture System.
EDIT: Minimizes picture
degradation during editing
(recording and playback).
Reduces image coarseness
SOFT:
when viewing overplayed
tapes containing a lot of noise.
SHARP: Clearer, sharper-edged
picture when viewing images
with lots of flat,
same-coloured surfaces such
as cartoons.
AUTO TIMER
8
ON
OFF
O.S.D.
8
ON
OFF
Your recorder is equipped with the Digital TBC (Time Base Corrector) that
removes jitter from fluctuating video signals to deliver a stable picture even
with old tapes and rental cassettes.
The on/off of Digital 3-DNR (Noise Reduction) which cuts noise and enables
clear picture reproduction is also linked to this function.
We recommend that you set "DIGITAL TBC/NR" to "ON" when...
... playing back a tape recorded on a camcorder.
... playing back a tape repeatedly used.
... using this video recorder as the source player for editing.
NOTES:
If you play back a tape recorded under poor TV reception condition, the
picture may become more stable with Digital TBC/NR set to off.
When "DIGITAL TBC/NR" is set to "ON", if you play back a tape where
certain types of signals are recorded (using a PC or some character
generators), the playback picture may be distorted. If this is the case, set
"DIGITAL TBC/NR" to "OFF".
When playing back a MESECAM tape, Digital TBC/NR does not function
even though "DIGITAL TBC/NR" is set to "ON".
You can set the B.E.S.T. (Biconditional Equalised Signal Tracking)
system to "ON" or "OFF" (
This feature helps you to adjust the playback picture quality
according to your preference. Normally select "AUTO".
NOTES:
When you select "EDIT", "SOFT" or "SHARP", the selected mode will not
change until you select another mode.
When you select "EDIT" to dub tapes, be sure to select "AUTO" after you
finish dubbing the tapes.
When "B.E.S.T." is "OFF", "PICTURE CONTROL" switches automatically
from "AUTO" to "NORM".
When this function is set to "ON", the timer is automatically
engaged when the recorder power is turned off, and automatically
disengaged when the recorder is powered back on.
NOTE:
For safety, when "AUTO TIMER" is set to "OFF", all other recorder functions
are disabled while the Timer mode is engaged. To disengage the timer, press
(TIMER).
#
When this function is set to "ON", various operational indicators
appear on the TV screen. Messages appear in the selected language
( pg. 15, 16).
NOTES:
When you use this recorder as the source player for editing, be sure to set
"O.S.D." to "OFF" before starting.
During playback, the operation mode indicators may be disturbed
depending on the type of tape being used.
* The default setting is bold in the table below.
pg. 29).
59
EN