Table of Contents
Advertisement
E. BATTERY AND ELECTROLYTE
INSPECTION:
●This series uses a sealed battery so you do not have
to inspect electrolytes.
NOTICE:
●Absolutely do not open the lid of battery.
●Battery may produce flammable gas. Take care of sparks or flames
when changing or performing maintenance on batteries. or dealer.
●When not used for a long time, battery may self-
discharge. To prevent discharging place battery on a recharge
and store in a cool place.
If battery is stored on the motorcycle for a long period of time,
disconnect the negative terminal.
F. FUSE REPLACEMENT:
REMOVE:
●Turn off the cap of the fuse case and take out the fuse. ●Kick start several times
●If fuse connection is not good, the fuse will
overheat and breakdown.
TABLE OF CONTENTS
INSTALL:
●Install the fuse into fuse case and fasten the cap.
●Try to pull the fuse after installation. If loose, the
fuse can overheat and breakdown.
WARNING:
●Do not use any fuse larger than installed.
Doing so can cause wire melt down and fire.
●Use approved electrical parts from your Motofino distributor
●If cannot find out the reason, deliver the motorcycle to
distributor or service center for inspection and repair.
●Do not use high pressured water to wash around the side cover.
VIII. WHEN ENGINE WILL NOT START:
●Check gasoline fuel level.
●Make sure that safety switch is in the "on" position.
●Check the starting procedures.
●Check battery hook ups.
●Check that "flooding" has not occurred.
●Have a trained professional look at your scooter.
26
Hide quick links:
Advertisement
Table of Contents
