Recording - JVC HR-S6965EK Instructions Manual

18 basic features
before you start
Turn the TV on
Tune the TV to your
Video Channel or to its
AV mode
Choose a blank
cassette which has the
record safety tab still in
place
Record
Safety Tab
Load the cassette into
the VCR (see page 14)
PR
3
PR
AUDIO – –:– –
3
VPS/PDC
0000
5
? 30 SEC
PR
3
PR
PR
i
2 4
ENTER
LP00000-000
VCR/TV

Recording

TV signals being received by the recorder's built in tuner can be recorded
onto a video tape. You can 'capture' a TV programme using your VCR.
Choose a Programme
There are two ways to select a preset position of the VCR.
Press
PR
method one
select the channel that you wish to record.
Push the center part of the
method two
appears on the display panel. While the display is shown, turn the
right or left.
Set the Tape Speed
Press /. The current setting for the tape speed appears on the on-screen
display or the VCR display panel for about 5 seconds. Press /again to
change the setting while tape speed is displayed. You can choose Standard Play
(SP) or Long Play (LP). The picture quality on LP recordings will not be as high
as on SP recordings, but the tape will last longer.
Start Recording
There are two ways to start recording:
Press and hold T and then press . on the Remote Control.
method one
Press T on the VCR.
method two
Pause and Resume During Recording
On either the VCR or the Remote Control, press | to temporarily stop recording
and press . to resume. You cannot change the preset position on the VCR while
it is recording but you can while it is paused (see
of this page).
or the number keys on the Remote Control to
or
PR
JOG Dial
so that the preset position
JOG Dial
at the top
Choose a Programme
to the