Table of Contents
Advertisement
A B O U T ASSEMBLY
Figure 19
Figure 20
Make sure Oscillator
is partially inserted in
Figure 22
U
-Rubber
vacuum skirt
1. Put both white seals in the oscillator; hold them in
place.
2. Install the oscillator on the long gear shaft. Install the
ratchet gear on the shaft so that the teeth engage the
ratchet on the oscillator. Install the spring, ratchet
drum, pinion gear (large gear first), and cam (gear end
first) on the shaft (See Figure 19). Ilold the gears on the
shaft while installing them, and compress the clutch
spring to allow assembly to slip into place between the
posts (See Figure 19).
3. Install the long gear shaft and end blocks in the clean-
ing head with the large arm of the cam down (see
Figure 20).
4. Reinstall the short gear shaft, set screw and two gears
(See Figure 21); the small pinion gears and the shaft set
screw go on the side toward the end of the cleaner
-
away from the oscillator box. Make sure that the gears
engage the gears on the long gear shaft.
5. Install the oscillator chamber cap and clip it in place.
6. Install the rubber vacuum skirton the cleaner with the
word 'OUTSIDE' showing. Start at the large pin on the
back of the cleaner head (see Figure 22) and work
around the cleaner. Make sure the skirt is flush against
the stop strips on the cleaner head (see Figure 23).
7. Turn the cleaner over. If you removed the bumper and
brush ring, replace them now.
8. Install the lower body assembly in the shroud. Fasten
the cleaning head in place with
4
screws (2 long, 2 short
-
see Figure 24).
NOTE: Make sure that you do not dislodge the rubber
vac skirt while inserting the lower body assembly past
the brush ring.
#lo-1 6x1
-314" Screws
Center
Brush
Location
#lo-16x1"
Screws
Figure 24
Bottom View of Cleaner
If you have any questions, please call 1-800-752-0 1 83
Advertisement
Table of Contents
