Oeuf Elephant Crib User Manual page 4

AUSTRALIAN STANDARDS COMPLIANCE
WARNING: TO PREVENT FALLS THE MATTRESS BASE OF
THIS COT SHOULD BE ADJUSTED TO THE LOWEST
POSITION BEFORE THE CHILD CAN SIT UP RECOMMENDED
MATTRESS SIZE: 690 MM WIDE X 1300 MM LONG X NO MORE
THAN 120 MM THICK
RECOMMENDED MATTRESS SIZE This cot has been manufactured for use with a mattress
which measures 690 mm wide by 1300 mm long and 120 mm in thickness. The width and length
are specified because it is important that the gaps between the mattress and the sides and ends
of the cot will not exceed 40 mm. This is to minimize the risk of a child's limb becoming caught in
the gap. The thickness of the mattress has been specified to ensure that the depth of the cot is
greater than 500 mm with the mattress base in the lower position to minimize the risk of a child
climbing or falling out of the cot.
•FAILURE TO FOLLOW THESE WARNINGS AND THE ASSEMBLY INSTRUCTIONS COULD
RESULT IN SERIOUS INJURY OR DEATH.
•BEFORE EACH USAGE OR ASSEMBLY, INSPECT COT FOR DAMAGED HARDWARE,
LOOSE JOINTS, MISSING PARTS OR SHARP EDGES. DO NOT USE COT IF ANY PARTS
ARE MISSING OR BROKEN. ASK YOUR DEALER OR WRITE TO 3 FEET HIGH FOR
REPLACEMENT PARTS AND INSTRUCTIONAL LITERATURE IF NEEDED. DO NOT
SUBSTITUTE PARTS.
•WHEN CHILD IS ABLE TO CLIMB OUT OR REACH THE HEIGHT OF 90 CM , THE COT
SHALL NO LONGER BE USED.
•DO NOT PLACE COT NEAR WINDOW WHERE CORDS FROM BLINDS OR DRAPES MAY
STRANGLE THE CHILD.
•IF REFINISHING, USE A NON-TOXIC FINISH SPECIFIED FOR CHILDREN'S PRODUCTS.
•DO NOT USE A WATER MATTRESS WITH THIS COT
•UPON COMPLETION OF ASSEMBLY, BE SURE ALL SCREWS AND BOLTS HAVE BEEN
TIGHTENED SECURELY.
•A PERIODIC CHECK SHOULD BE MADE OF ALL SCREWS AND BOLTS AND RETIGHTENED
IF NECESSARY.
•NEVER USE PLASTIC SHIPPING BAGS OR OTHER PLASTIC FILM AS MATTRESS COVERS
BECAUSE THEY CAN CAUSE SUFFOCATION.
•DO NOT DRAG COT.
•AFTER COT HAS BEEN COMPLETELY ASSEMBLED, STORE INSTRUCTION SHEET IN
THIS POUCH.
•UNDER NO CIRCUMSTANCES SHOULD THIS WARNING BE REMOVED FROM MATTRESS
SUPPORT!
WARNING: TO PREVENT FALLS, THE
MAXIMUM MATTRESS THICKNESS SHOULD
NOT EXCEED 120 MM.
3