Specifications - Dixon ZTR 4000 series Operator's Manual

CHASSIS:
BODY:
MOWER DECK:
BLADE DRIVE:
TRANSMISSION:
ENGINE:
Model 4423:
Model 4424:
STARTING SYSTEM:
TIRES:
RECOMMENDED
TIRE PRESSURE:
CAPACITIES:
DIMENSIONS:

SPECIFICATIONS

Models ZTR 4423 & ZTR 4424
The monocoque design chassis of the Models ZTR 4423 and ZTR 4424
incorporate CNC Laser and CMC brake processes to form the twin 12 gauge side
frames and 7 gauge transmission and engine base plate.
All body parts are made of rotational molded, high density polyethylene. Front
body contains access panel for battery service. Seat lifts forward or backward for
a variety of service points in the transmission area.
13 GA stamped steel construction.
(3) blades combine for a 42" cut width.
Cut height approximately 1
Electric clutch.
Each rear wheel is independently driven by chain and sprockets through a
friction, mechanical drive.
14 HP Vanguard Briggs & Stratton, 4 -Cycle, Single Cylinder, Overhead
Valve, Air-Cooled, Gasoline, Vertical Shaft With Cast Iron Cylinder Sleeve,
Oil Pump With Integral Oil Filter.
15 HP Kohler Command 15, 4 -Cycle, Single Cylinder, Overhead Valve, Air-
Cpoled, Gasoline, Pressure Lubricated, With Oil Filter, Vertical Shaft,
Aluminum Head and Block with Cast-iron Cylinder Liner.
Electric by key switch operation with safety interlock blade drive.
Front 11 X 4.00 X 5 ribbed tread.
Rear 18 X 9 . 5 0 X 8 Turf Trac RS
Front 16-21 Ibs.
Rear 8-14 Ibs.
Fuel 2.7 gallons total.
Engine Briggs & Stratton -1.50 quarts oil.
Kohler - 2 quarts oil with filter.
Width 47" outside rear wheel measurement.
Height 42" to top edge of seat.
Length 72" hitch tab to front bumper.
Weight 520 Ibs.
NOTE: Additional information provided in service instructions under
the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
B
1o-4" via 8 position lift handle.
Page 9