Table of Contents
Advertisement
4
EN
Auto Set Up
Auto Channel Set
1
4
7
/
ATTENTION
Once you have performed Auto Set Up, even if the
recorder's memory backup has expired, all the stored
stations remain in the recorder's memory and the recorder
will not perform Auto Set Up again.
If you have moved to a different area or a new station starts
broadcasting in your area, perform tuner setting.
DO NOT press any button on the recorder or remote control while Auto Set Up is in progress.
On-Screen Display
During Auto Set Up
The channel numbers are displayed as they are scanned
and set.
Front Display Panel
NOTE:
If you want to set the tuner manually such as to add or skip channels, to swap channel positions, or to fine-tune channels,
pg. 25.
2
q
5/8
2
3
5
6
8
9
0
4
AUTO CH SET
PLEASE WAIT
START
FINISH
When the
for the first time to power on the recorder after you plug the
mains power cord into a mains outlet, the Auto Set Up function
sets the tuner channels automatically.
You can refer to the front display panel and/or the on-screen
display to perform this procedure.
Before starting, make sure of the following:
The TV aerial cable should be connected to the recorder.
The recorder's mains power cord should be connected to
a mains outlet.
If you want to use the on-screen display, the TV should
3
be set to its AV mode (with AV connection
UHF channel 36 (with RF connection
START AUTO SET UP
1
Press
The Auto Set Up function scans all the channels that
are receivable by your recorder. It then automatically
assigns each receivable channels to the TV PROG
buttons. It skips non-receivable channels.
As Auto Set Up progresses, the "
screen moves from left to right.
After you perform Auto Set Up, if the tuner channels
have not been set properly or if "CH – –" is displayed
on the front display panel, make sure that the aerial
cable is connected to the recorder properly and turn
off the recorder power once, and turn the power back
on to try Auto Set Up again.
If there is a power cut, or if you press
while Auto Set Up is in progress, Auto Set Up will be
interrupted; be sure to turn off the recorder power once
and try again.
pg. 24
When Auto Set Up is completed, the lowest position
number will appear on the front display panel.
INITIAL SETTINGS
button on the recorder/remote control is pressed
pg. 3
.
TV Screen
pg. 3) or
pg. 3).
" mark on the
or MENU
Advertisement
Table of Contents
