Table of Contents
Advertisement
4
EN
Auto Set Up
Auto Cha nnel Set
ATTEN TIO N
Once you have performed Auto Set Up, even if the
recorder's memory backup has expired, all the stored
stations remain in the recorder's memory and the recorder
will not perform Auto Set Up again.
If you have moved to a different area or a new station starts
broadcasting in your area, perform tuner setting.
D O N O T press any button on the recorder or remote control while Auto Set U p is in progress.
O n-Screen D isplay
D uring Auto Set U p
"PLEASE WAIT" blinks on the screen and "Auto" blinks on
the front display panel.
Front D isplay Panel
N O TES:
● If you have connected your TV to the recorder with RF connection and the on-screen display appearing on UHF channel 36
looks distorted, refer to the front display panel.
● If you want to set the tuner manually such as to add or skip channels, to swap channel positions, or to fine-tune channels,
pg. 22.
Downloaded from:
https://www.usersmanualguide.com/
2
1
2
3
4
5
6
8
7
9
/
0
4
AUTO CH SET
PLEASE WAIT
START
When the
for the first time to power on the recorder after you plug the
mains power cord into a mains outlet, the Auto Set Up function
sets the tuner channels automatically.
You can refer to the front display panel and/or the on-screen
display to perform this procedure.
Before starting, make sure of the following:
● The TV aerial cable should be connected to the recorder.
● The recorder's mains power cord should be connected to
a mains outlet.
● If you want to use the on-screen display, the TV should
3
be set to its AV mode (with AV connection
UHF channel 36 (with RF connection
q
5/8
6
ST ART AUTO SET UP
1
Press
● The Auto Set Up function scans all the channels that
● As Auto Set Up progresses, the "
● After you perform Auto Set Up, if the tuner channels
● If there is a power cut, or if you press
pg. 21
FINISH
When Auto Set Up is completed, the lowest position
number will appear on the front display panel.
IN ITIAL SETTIN GS
button on the recorder/remote control is pressed
pg. 3
.
are receivable by your VCR. It then automatically
assigns each receivable channels to the TV PRO G
buttons. It skips non-receivable channels.
screen moves from left to right.
have not been set properly or if "CH – –" is displayed
on the front display panel, make sure that the aerial
cable is connected to the recorder properly and turn
off the recorder power once, and turn the power back
on to try Auto Set Up again.
while Auto Set Up is in progress, Auto Set Up will be
interrupted; be sure to turn off the recorder power once
and try again.
TV Screen
pg. 3) or
pg. 3).
" mark on the
or M EN U
Advertisement
Table of Contents
