Kenwood TS-820S Instruction Manual page 37

Fig. 29 Connection of Accessory Remote VFO
EXTENSION FEET
The TS-820S is provided with two extra feet which can be
used to raise the front panel of the transceiver. In some
operating positions the tilt makes it easier to read the dial
and meter. Fig. 31 shows how to install the feet.
REMOTE CONNECTIONS
Fig. 30 shows the REMOTE connector. This 8-pin plug
can be used for attaching linear amplifiers. or other external
accessories to the transceiver.
r-
r 'RL
I -.-I
Fig. 31. Attaching the Extension Feet
To an external speaker
FIXED CHANNEL CRYSTAL INSTALLATION
Section 4.1 5 describes fixed channel operation with the TS-
8205. To install the accessory crystals, reemove the
transceivers bottom cover and locate the FIX-VOX board
side the power transformer.
Fig. 30 Remote Connector
Insert the crystal in the desired channel position (the posi-
tions are labeled on bottom of the case) and use the appro-
priate trimmer (TC1 through TC4) to net the crystal. The
CAL-FIX feature of the TS-820S can be used to net the
crystals as described in Section 4.4.
37