Related Manuals for Aurora Design FMR-1
Summary of Contents for Aurora Design FMR-1
- Page 1 Aurora Design Dealer Name: FMR-1 Date: Job #: User Installation and Operation Manual Aurora Design LLC. ©2013 Rev 1.3...
-
Page 2: Audio Output
For a 1 speaker installation the speaker can be connected to any one of Speaker Impedance: 4-32Ω the four outputs. The FMR-1 will detect that only one speaker is attached Output Power: 4 X 45W into 4Ω @ 14.4V max (EIAJ) and enable mono mode while disabling the balance and fader controls. - Page 3 ☐ Power - 6V positive ground have entered the virtual balance control. You may adjust the balance for as long as you wish. When finished, the FMR-1 waits a few seconds and then signifies that the setting was accepted by playing a ☐ Original Power lead...
-
Page 4: Troubleshooting
When you switch from volume to faults are found, each of these patterns will be followed by a long pause tone, the FMR-1 will hold the volume steady until you return to the and the next fault will be displayed.
Need help?
Do you have a question about the FMR-1 and is the answer not in the manual?
Questions and answers