Radio Shack TRS-80 Model II Reference Manual page 91

Library Commands
RECEIVE
Receive Object Code via
RS-232-C
t.tel'lsJ"FlSDO:S tal of1:set each load address
il1Qdata (~)ee "Required Data Format",
I"lUhAfI"lIlI"lIA/'inn
forms:
f.hei data I()adad(jre~)s is
This command lets you receive object code into RAM from another device (a Model
I, II, or III, or other computer). The data must be sent in Intel Hex Format as
described later on.
Before using RECEIVE, you initialize one of the serial channels with SETCOM.
Select the appropriate parameters, depending on the requirements of the
transmitting device.
Notes
1. The data will be loaded into memory according to the load information
contained within the data. It must load above
X'2FFF
and below the top of user
memory. (Execute the SETCOM command, then use the STATUS command to get
this last value.)
2. If the data load address is out of this range, you can use the offset option to bring
the load address into the desired range. Then, when the data is DUMPed into a
program file, use the RELO
=
hhhh option to specify the original load address.
127