Advertisement
32. Check that all wire harnesses are routed properly
and all connectors are plugged in.
33. Reinstall the grab rail; remove the two clips from
the vehicle. After installing the clips and caps on
the grab rail, reinstall the grab rail on the vehicle.
CLIPS
(2)
SECTIONAL VIEW
34. Reinstall all removed parts. Check that all clips
and other fasteners are installed securely. Take
care not to pinch the airbag with a clip during
reinstallation of the front pillar trim. Do not push
the front pillar trim excessively.
35. Reconnect the negative cable to the battery.
36. Enter the customer's radio anti-theft code, and
reset the radio station presets.
37. Reset the clock.
38. If the IMA battery level gauge (BAT) displays zero
segments, start the engine, and hold it between
3,500 and 4,000 rpm (in Park or Neutral) until the
IMA level gauge (BAT) displays at least three
segments.
39. Check the operation of the automatic day/night
mirror according to the Owner's Manual supplied.
8 of 8
CAP
VEHICLE
FRONT
PANEL
LEFT
FRONT
GRAB RAIL
5308590T
NOTE: Because the battery was disconnected, enter
the Honda multi-matic feedback signal as described in
the service manual.
•
When the battery is disconnected, the driver's
window AUTO function is disabled.
•
Start the engine. Push down on the driver's window
switch until the window is fully open.
•
Pull up on the driver's window switch to close the
window completely, then hold the switch for
2 seconds or more.
•
Lower and raise the driver's window to check
operation of the driver's window AUTO function.
AII 30339 (0602)
© 2006 American Honda Motor Co., Inc. - All Rights Reserved.
Advertisement
